Both OmniSquares + Stair Gauges Set + FREE Shipping
The OmniSquare is a precise 90 and 45 degree square, a Combination Square, T Bevel Square, and T Square, a Depth Gauge and Compass — All in one square.
Stair Gauges set your framing square or rafter square up to precisely layout stair tread and riser cuts on stair stringers, and rafter hip, tail, and birds mouth cuts. As an additional use, they set up your square as a Big Try Square, and more!
FREE USPS 1st Class Shipping (3-5 days) on ALL orders.
PLUS Save 5% on ALL orders over $50 and 10% on all order over $100 — Discount automatically applied at checkout! See below for full product information.
Watch this short video below to learn more about what the Omni Square is and how to use it:
The OmniSquare is a precise 90 and 45 degree square, a Combination Square, T Bevel Square, and T Square, a Depth Gauge and Compass — All in one square.
Folds and can be carried in your back or side pocket — very handy.
Easily sets to all positions shown in a couple of seconds.
Angles and markings accurate to within .003" the entire length of the blade - literally 2 hairs.
Made fully here in the USA - by the inventor and long time tradesman himself!
All parts Anodized Aluminum or Stainless Steel - nothing to rust.
More uses than any square we've seen.
Made to be used and to last a lifetime.
Takes the place of multiple squares.
Deep laser etched markings.
Watch this short video below to learn more about what the Stair Gauges are and how to use them:
Stair Gauges open to .140 inch, clamping onto any square I know of, steel or aluminum, EXCEPT the .1875 Inch (3/16) thick Milwaukee MLSQ024.
Stair Gauges set your framing square or rafter square up to layout stair stringer tread and riser cuts, and rafter hip, tail, and birds mouth cuts.
Essentially turns your square into a big Try Square.
Set one of the gauges a specific distance from the blade as a marking gauge for laying out studs or repetitive cut lines, like blocking, etc..
Sets up easy, fast, and very precisely.
Stair Gauges are 1 1/2" wide, corresponding to standard 2X lumber.
3/4" Ledges support square on lumber or steel “hands free”.
3/4'“ Stops span most chip out on lumber or steel tube radius's, and align perfectly with the edge of your square, so the inch markings on the blade are still correct.
The Stair Gauge’s Lever clamps don't mar your square.
Patent pending.